Latest News
Items: Flipsky 75100 75V 100A Single ESC Throttle Accelerator Bar Brake Handle Simple forward / reverse switch (for demonstration purposes) Adapter wire (for GND connection) GND wire*2pcs ADC mode Reverse and Cruise Mode wiring diagram: 1. After the motor FOC settings,...
Continue reading
The default maximum voltage of vesc_tool is 72v. So, if your battery voltage is over 72V. What should you do? Here belows FYI. 1.Click “Welcome&Wizards”--“AutoConnect” 2.Click “Firmware”--”Bootloader”. Do firmware Bootloader 3.Firmware reflash and upload after bootloader done, choose 75_300_R2 and the VESC_default_no_hw_limits.bin 4....
Continue reading
1.After upgrading the firmware of 75 series ESC to the latest 5.3 firmware, set the "Phase Enable Filters" selection to: FALSE, according to the following figure, and write in at the same time, and go to the next automatic parameter...
Continue reading
Mini FSESC4.20 Mini FSESC6.7 Voltage 8～60V（3～12S safety） 14V-60V（4～12S safety） Max Continuous Current 50A 70A Instantaneous Current 150A 200A ERPM 60000ERPM 150000ERPM Driver DRV8302 DRV8303 Current Sampling Resistor Two 1mR domestic manganese copper resistors Three 0.5mR imported manganese copper resistors Mosfet...
Continue reading
1. Why does the ESC flashes red light and indicates overvoltage? When the voltage of the power supply exceeds the voltage set on vesctool, a red light flashes to indicate that the voltage is too high. Please change the maximum...
Continue reading
