Tips for flipsky 75 series ESCs upgrade (firmware 5.3)

1.After upgrading the firmware of 75 series ESC to the latest 5.3 firmware, set the "Phase Enable Filters" selection to: FALSE, according to the following figure, and write in at the same time, and go to the next automatic parameter settings:

2.The first step when enter the parameters setting interface is to select "NO" according to the following figure, no matter dual-drive or single-drive.

3.Detect FOC Parameters: Tick if it is a dual-drive ESC, untick if it is a single-drive ESC.

 

Flipsky 75 series escs:

75100: https://bit.ly/3ICYDR0

75200: https://bit.ly/3564aC2

Know more details of firmware update here: 


Leave a comment

Please note, comments must be approved before they are published