Latest News
After finishing the motor FOC settings, the remote VX4 cannot drive the motor after plugging the receiver in escs (based on vesc) UART COMM port. What should do? Here the tips FYI. 1. Please check the remote receiver. Do not...
Continue reading
PPM Control 1.Select PPM in remote setting "Control Type". 2.Remote enter into pairing .PPM wire connect to receiver, and pairing succeed. 3.Setting in VESC TOOL:"General"-App to Use"PPM"-Write in.Setup Input-PPM input-Next.Throttle calibration-Next-Finish. 4.PPM control mode does not show real-time data. UART...
Continue reading
News:FLIPSKY VX2 pro has been upgraded from VX2_3.7 to VX2_3.8 . The main updates are as follows: 1. Replace the transmitter antenna.2. Optimize the pairing algorithm.3. Optimize the communication algorithm.4. Add signal strength indicator. The receivers and remotes of VX2_3.7 to VX2_3.8 cannot...
Continue reading
News:FLIPSKY VX3 has been upgraded from VX3_V1.2 to VX3_V1.4. Updates below: 1.Pairing Optimized Changed from a single pairing channel to a random pairing channel. Optimized the pairing process and increased the step judgment of the pairing process. Optimized the pairing sequence to increase...
Continue reading
News:FLIPSKY VX3 has been upgraded from VX3_V1.0 to VX3_V1.2. Updates below: 1.The throttle accuracy has been optimized. VX3_V1.0 throttle calibration interface:The speed display range is generally around 136~165, range 29; Break display range is generally around 138~167, range 29. VX3_V1.2 throttle calibration...
Continue reading