How to control two ESCs synchronously via remote VX1?

When you DIY something needs to control two ESCs synchronously but have no ideas about how to do it successfully, hope this blog can help you. The tutorials FYI.

Items:

Remote controller VX1 *1

Remote Receiver *2

FSESC 75100 V2.0 *2

Step 1 Pairing Two Receivers

Firstly, power on the remote VX1, and then long press two buttons at the same time until the remote vabrates with blinking red led to enter into pairing mode.

Then, connect the first receiver and make the receiver have solid blue LED after pairing successfully. Whereafter, remove the first paired receiver to do the same steps to do pairing for the other remote receiver. 

Finally, after two receivers' successful pairing, connect both of them to check the status and make sure they have solid blue LEDs.

Step2: PPM Input Setup Separetely

The ESCs need to do input setup separetely, so plug one esc with receiver at first. Then power on the esc and connect it with the computer via USB.

Reconnect the VESC_Tool after motor FOC settings and do PPM input setup.

Click “AutoConnect”→”Setup Input”→”Next”

Select “PPM input” and then click “Next”

Pull/push the throttle to the max to do throttle calibrate mapping, then click “Apply” and “Next”.

Choose the desired control type and then click “↓A”write in. Finally, click "Next” and”Finish”.

Push the throttle check if the esc can drive motor normally and then do input setup for the other one (repeat the steps as the first one).

Connect two receivers to test and drive them at the same time.