Spec:
- Firmware: 6.02, supports firmware upgrade
- Voltage: 14-84V (safe for 4-20S)
- Continuous current: 50V/200A; 75V/150A (Values depend on the mounting,
- ambient temperature and air/water circulation around the device!); Burst: 300A
- BEC: 5V@1A
- Support Modes: DC, BLDC, FOC (sinusoidal)
- ERPM: 150000
- Communication Ports: USB, CAN, UART, SPI, IIC
- Supported Sensors: ABI, HALL, AS5047, AS5048A
- Input Source Support: PPM, ADC, NRF, UART
- Supported Sensorless: Yes
- Regenerative capacity: Yes
- Programmable via VESC_TOOL: Yes
- Size:130x68x41mm
- Motor/power wire size: 8 AWG
- Phase Filter: Yes
- Power Switch Button: Red
Feature:
- Adjustable protection against: low voltage protection, high voltage protection,over current protection, temperature abnormal protection, mosfets / motor over temperature protection.
- Support various control modes: Current / Duty cycle / Speed / PID control modes.
- Support the function of balancing car by connecting the IMU module through the
- IIC interface; support inertial measurement unit modules such as MPU9250,
- MPU9150, MPU6050, LSM6DS3, BMI160.
- CPU:32F405 with frequency 168MHz
- Aluminum PCB with good heat dissipation to expand life span.
- 75200 Pro V2.0 aluminum substrate single drive: supports single serial port function,and integrates Bluetooth module function (convenient to connect Bluetooth parameters and read data in real time),and built with power on/off switch.
Wiring diagram:
