FLIPSKY FSESC6.9 100A base on VESC6.6 With Aluminum Anodized Heat Sink
Warm tips:
It is recommended to keep firmware 5.2 from factory ship, the new firmware upgrade may damage the ESC.
Specs:
- Firmware: Latest Version
- Continuous current: 100A; instantaneous current: 200A
- Voltage: 14V-60V(Cells: 4-13S; safe for 4S to 12S, voltage spikes may not exceed 60V! )
- BEC: 5V@1A
- ERPM: 150000
- Control Interface Ports:USB,CAN,UART
- Supported Sensors:ABI，HALL，AS5047，AS5048A
- Input Set Support:PPM, ADC, NRF, UART, SPI, IIC
- Modes:DC, BLDC, FOC (sinusoidal)
- Regenerative capacity: Yes
- Programmable: Yes
- Motor wire: 10AWG
- Power cable:8AWG
- Size:75.4x63.7x31.1mm(Including heatsink)
Feature:
- Support four control modes: Current/Dutycycle/Speed /Position control mode.
- Using 6pcs SFT01N10T high current MOSETS (100V 500A).
- Protection functions: low voltage protection, high voltage protection, over-current protection, temperature abnormally protection, mosfets over-temperature protection.
- Support the function of balancing car by connecting the IMU module through the IIC interface; support inertial measurement unit modules such as MPU9250, MPU9150, MPU6050, LSM6DS3, BMI160.
Wiring diagram:
