Flipsky Dual FSESC6.7 Plus based on VESC6 With Power Button

Warm tips:

It is recommended to keep firmware 5.2 from factory ship, the new firmware upgrade may damage the ESC.

Warm tips: please do not remove the shrink to protect the pcb electronics components from impurites or metals which result in short circuit or esc burnt damage.

Upgraded features:

• PLUS switch version:
• Power on/off by pressing the button
• Added Can bus connector, be more convenient for 4WD set up
• Changed the USB port soldering process to SMT soldering instead of manual soldering
• Changed the big capacitors to SMT mounting capacitors ,and add more mosfets in the bottom side.

Spec:

- Hardware: V 6.7

- Firmware: Latest firmware version

- Voltage: 8V - 60V (Safe for 3S to 12S LiPo) for the dual ESC

- Voltage spikes may not exceed 60V

- Continuous 100A single, total 200A 

 -Instantaneous current 400A per single, total 800A for system instantaneous current. values depend on the mounting  and ambient temperature around the device!

- 5V 1.5A output for external electronics for single

- 3.3V 1A output for external electronics for single

- Modes: DC, BLDC, FOC (sinusoidal)

- Supported sensors: ABI, HALL, AS5047

-ERPM:150000

-Size: 83*27.3*18.3mm（WITH ALU CASE）

-Size: 78*78*27.3mm（WITH Heat Sink）

-Motor wire: 12AWG

-Power cable:8AWG

-Recommend bullet connectors: 4MM Bullet Connector 

          -Reminder: Detected battery voltage tolerance: +/-0.6V 

The shipping package contains:

• 1*Dual FSESC6.7 Plus
• 2*VESC Sensor Wires
• 1*LED button 
• 1*Micro USB
• 1*Manual

Dual FSESC6.7 Wiring Diagram:

DUAL FSESC6.7 PLUS with AUL CASE SIZE:

Programming Tutorial Reference (VESC tool 1.16)