Input source: PPM, analog, NRF NYKO KAMA NUNCHUCK;
Communication ports: USB, CAN, UART;
Motor wire: 12 AWG
Power cable: 12 AWG
Remark: Before unplugging the switch button, pls pressing the switch button to turn off.
Feature:
Support BLDC square wave mode control and FOC sine wave mode.
High current 60V Infineon mosfets in 6 Directfet packages;
Traction setting (support single and dual setting)
Support with Hall, without Hall, with sensor, and without sensor;
Throttle curves and slopes of all input sources, seamless four-limit operation, count of motor revolutions, ampere-hours, watt-hours, real-time data analysis and readout through the communication port;
The digital VCC and analog VCC are generated by different voltage regulators, which makes the system's AD conversion more accurate;
Adjustable protection measures: low input voltage/high input voltage/large motor current/high input current/over-temperature protection (MOSFET and motor);
High regenerative braking current (separate limit for motor and input), high RPM (different limit for each direction), nearly one hundred setting parameters can be changed through the USB port using the host computer software VESC_TOOL and kept in the ESC;
Flipsky Dual 75100 With Aluminum PCB Based on VESC For Electric Skateboard / Scooter / Ebike Speed Controller
Regular price$262.00
0 in stock
Specs:
Size:L107mm*W103mm*H18.5mm
Voltage:14-84V (4-20S safey)
Current:continuous max 100A single,dual continuous max 200A,values depend on the mounting and ambient temperature around the device!
BEC:5V@1A
Support BLDC square wave mode control and FOC sine wave mode
Firmware: latest (firmware update supported)
ERPM:150000
Control Interface Ports:USB,CAN,UART
Supported Sensors:ABI，HALL，AS5047，AS5048A
Input Set Support:PPM，ADC，NRF,UART
Wire Size: 12AWG
Programmable: Yes
Regenerative Capacity: Yes
Warm tips:
Phase filering is not available for Flipsky ESC75100 and 75200! Please turn off the phase filter function and choose "false" in vesc_tool when use firmware version on or above 5.3 (VESC_TOOL 3.01). Without turning off the phase filter will result in esc damage. Please do not restore the default parameters when using the wizard interface. Here below video and blog links FYI. YouTube：https://bit.ly/3IIV0ci Blog：https://bit.ly/3JBRRMR
Wiring diagram：
2.4Ghz Remote VX1 Pro for DIY electric skateboard
Regular price$59.90
-7 in stock
Features:
Using 2.4G wireless module-E28-2G4M12S, low power consumption, strong anti-interference ability, long remote control distance
Support 3 speed modes (high gear: red light; middle gear: yellow light; low gear: green light)
Support cruise control mode
Remote control and skateboard battery indicator light
Comfort touch: ABS+Rubber painting surface
Support reverse function
Rechargeable Li-ion Battery (850mAh)
Anti-slip wrist strap
VX1 Remote comes with Receiver
Kindly Reminder ! 1.Please carefully check following receiver connection diagram corresponding with different FSESC, wrong cable collection in reciver side will cause the receiver burned.
2. The variants (for VESC4/ for VESC6 / For Non VESC) only differenciate on reciver cables , the remote is the same one.
