1.Please carefully check following receiver connection diagram corresponding with different FSESC, wrong cable collection in reciver side will cause the receiver burned.
2. The variants (for VESC4/ for VESC6 / For Non VESC) only differenciate on reciver cables , the remote is the same one.
3. When you choose UART mode connection for VX1 remote receiver, pls do connection after your programming in VESC tool. Or else , it will influence programming. And In UART mode, there is no need to do adjust for remote.
Receiver Connection Diagram
For Single V4
For Dual FSESC4.20: Both hook up with bluetooth and remote receiver
For Single V6
For Dual FSESC6.6 Plus : both hook up with bluetooth and remote receiver
Dual FSESC6.6 Based upon VESC6 with Aluminum Heatsink
-341 in stock
Big Size Dual FSESC6.6 Based upon VESC6 with Aluminum Heatsink
Dual ESC can reach continuous 200A big current, give your board strong power
One PCBA board integrate two FSESC6 ’s function by internal CAN BUS circuit connection.
The mater and slave board connection can be switched On/Off
Preserve Bluetooth module and RF module connections for both master and slave board
Aluminum anodized Heat sink with fins design for better heat dissipation
size with heatsink: 128.5x91x21mm (L*W*D)
PCB layers: 8layers, thickness: 3oz/layer, total 24 oz thickness
Hardware: V 6.6
Firmware: Latest firmware version
Voltage: 8V - 60V (Safe for 3S to 12S LiPo) for the dual ESC
Voltage spikes may not exceed 60V
Current: Continuous 100A single, total 200A , Instantaneous current 400A per single, total 800A for system instantaneous current. values depend on the mounting and ambient temperature around the device!
5V 1.5A output for external electronics for single
3.3V 1A output for external electronics for single
Modes: DC, BLDC, FOC (sinusoidal)
Supported sensors: ABI, HALL, AS5047
6 shunts in dual system. Each is measurable for the current.