Brand new and high quality Connect RC battery to electronic equipment Low resistance and gives the best electric flow PERFECT For RC Drones, Helicopters, Planes, Cars & Trucks Diameter: 4mm Quantity: 1 Pairs = 1 Male & 1 Female
1.Please carefully check following receiver connection diagram corresponding with different FSESC, wrong cable collection in reciver side will cause the receiver burned.
2. The variants (for VESC4/ for VESC6 / For Non VESC) only differenciate on reciver cables , the remote is the same one.
3. When you choose UART mode connection for VX1 remote receiver, pls do connection after your programming in VESC tool. Or else , it will influence programming. And In UART mode, there is no need to do adjust for remote.
Receiver Connection Diagram
For Single V4
For Dual FSESC4.20: Both hook up with bluetooth and remote receiver
For Single V6
For Dual FSESC6.6 Plus : both hook up with bluetooth and remote receiver
To compile this code, a library function "ILI9225.h" will need to be added: Click "Project","Loading Library", "Managing Library", search for "ILI9225", and install it to compile.
The baud rate of the UART of the FSESC should be 115200
The default data displayed on the screen (speed, mileage, and parameters required for the average battery voltage of each cell ) are pre-coded in the program, so it should be calculated according to the actual situation of the skateboard. After modifying data in the source code, flashing the modified program in it.
Parameters required for speed: erpm, motor pole pairs, motor pulley teeth, wheel pulley teeth;
Parameters required for mileage: tachometer, motor pole pairs, motor pulley teeth, wheel diameter;
Modifying the parameters in the "davega_config.h" file according to your skateboard, otherwise the displayed speed and itinerary will not be accurate.
The default is 12S battery. This parameter will affect the display of the average voltage. It can be changed in the “davega_config.h” file if you’re not using 12s battery.
After quick pressing the button 3, the battery capacity (mAh) in the displayed data is calculated according to the number of VESCs used. For example, if two VESCs are used, then changing the VESC COUNT in the “davega_config.h” file to 2 ; if one VESC is used, then changing the VESC COUNT to 1.
3.3V 5V FT232RL FTDI USB To TTL Serial Converter Adapter Module For Arduino
-3 in stock
3.3V or 5V TTL voltages (can be set with a jumper)
Converts TTL logic levels to computer RS232 levels
Power supplies: 5V, 3.3V, GND (min)
RX (3.3V or 5V *)
TX (3.3V or 5V *)
Mini USB female connection
Choose the 3.3V or 5V by using the black hat to cover the pin in red mark area.
Anti Spark Switch Pro 280A for Electric Skateboard /EBike /Scooter/Robots
-344 in stock
PCB thickness: 6 layer*3oz copper=18oz copper
Max continuous 280A, Burst current 800A
Max voltage: 13S (60V)
Dimensions(with heatsink and heat shrink): 40mm*28.5mm*9.1mm
LED button diameter: 12mm
Reminder : the LED button is defaultly inserted in the switch in shipping status, DO NOT power on switch without the LED button connected.